MORBON plus admix is a ready to use, multi-purpose, Latex Emulsion Polyer, specially designed for use with cement Mortar, Cement-Sand Mortar, Cement-Based Tile Adhesive and Cement-Based coloured Grouts in a variety of building applications.
* Admixture for Tile Adhesive :-
Range of cement-based Tile Adhesive for installation of Ceramic Wall and Floor Tiles, Vitrified Tiles, Mosaics,Quarry Tiles, Terracoatta, Marbles,Granites,Slates, Terrazzo, Brick Veheer, Decorative Stones to wall and floor, dry or wet, interior or exterior areas including swimming pools.
When fixing Natural Slabs or Ceramic Tiles to External areas, Smooth concrete, Swimming pools, Substrates subjected to movement, Impervious surfaces, wet duty areas, heavy traffic areas, Building Boards or when fixing water impervious tiles / stone slabs.
* Admixture for Tile Grout :-
Range of coloured grout for filling joints of Ceramic Wall and Floor Tiles, Vitrified Tiles, Mosaics,Quarry Tiles, Terracoatta, Marbles,Granites,Slates, Terrazzo, Brick Veheer, Decorative Stones for use at wall and floor, dry or wet, interior or exterior areas including swimming pools.
When grouting joints of Ceramic Tiles or Natural Stone Slabs External areas, Smooth concrete, Swimming pools, Substrates subjected to movement,glass mosaics, porcelain tiles or tiles with glaze edge, wet duty areas kitchen, toilet,shower,etc. heavy traffic areas, re-grouting worn joints etc.
Stir or shake BUILDPLAST MORBON Plus Admix thoroughly before use. Add BUILDPLAST Standared Grouts powder to proper amount of BUILDPLAST MORBON Plus Admix and mix by hand or with a slow speed mixer (< 300 RPM) to a smooth, stiff consistency. Dampen tile surface with water. Spread with a sharp, firm rubber grout float. Work the grout into the joints until completely filled. Use diagonal strokes to pack the joints. Insure that joint is filled and grout is not just sitting on top. Note: For fuller flush joints sprinkle a thin layer of dry grout powder over surface immediately after grouting. When grout darkens over joint, buff with burlap, carpet remnant or cotton rag to pack joint and clean face of tile.
200 ml , 400ml ,1tr, 5ltr & 20 ltr.
Used in place of water, BUILDPLAST MORBON Plus Admix improves the performance of Portland cement grouts. Designed for interior and exterior floor and wall joints of all types of ceramic tile, vitreous, semi-vitreous tile, glass mosaic tiles, terrazzo, brick, marble, natural stone and agglomerate stone installation.
200 ml per kg of BUILDPLAST Standared Grouts.
2 (Two) years shelf life if stored in cool and dry area in unopened containers, protected from sun light.
Apply liberal amount of clean, cool water to the grouted area. Adding a few drops of dishwashing liquid to the water will aid in clean up. Using a soft sponge, work in a circular motion to loosen grout film and finish joints smoothly. If necessary add more water to aid cleaning. Clean film from tile with a damp cotton towel and clean water. Change rinsed water frequently to aid cleanup and minimize grout residue left behind. Fingertip can be used to smoothen the joints but care to be taken because flush joint may not get while fingering over grouted joints. Final cleaning can be done on similar way after 24 hrs of first cleaning or after the grouts sets firmly. Time will vary depending upon substrate and ambient temperature. Do not do final cleaning before the grout joints sets firmly.
Remove excess grout by holding grout float at 70° to 90° angle and pulling the float diagonally across the grout joints. Removing as much material as possible will make final cleaning easier. Allow joint to set for approximately 2 – 3 hours or until they begin to firm. Time will vary depending upon substrate and ambient temperature.